Transrotor TRA Studio

After 50 years of designing and building world class turntables, Jochen and Dirk Räke, who has steered the fate of Transrotor for the past twelve years, made the decision to design and build their own Transrotor tonearm. With the immense practical experience, knowledge of turntables, setup and access to the most modern production method the team set out to design the new tonearm. Material: Aluminium alloy, stainless steel, brass, ceramic, magnetic material, technical plastics, silver, anodized Counterweights: Aluminium alloy with interchangeable extra weights (depending on cartridge weight) VTA adjustment: two screw-in adjustment screws lift the tone arm parallel Scating setting: Magnetically adjustable via a fine thread, center adjustment 1.8 g (gram) (red line) Cabling: Van Den Hul, cartridge connection cable plugs silver-plated Connection cable: Van Den Hul 502, fixed, SME/DIN-plug on request Connection plug: RCA or XLR special high conductive coated (WBT) The tone arm is compatible with all 9-inch SME bases manufactured by Transrotor with an extra adaptor Technical data Effective length: 232.8 mm (approx. 9 inches), Tone arm distance: spindle to tone arm pivot point 215 mm, Overhang: 17,8 mm, Offset: 23.66 degrees, Zero point inside: 66 mm, Zero point outside: 121 mm, Effective mass: 18 grams (mid heavy, fitting to almost all cartridges), Connection cable: length approx. 130 cm, Cable material: Van Den Hul.